On Sat, 28 Jul 2001, Patrick M. O'Laughlin wrote:
>> > zedit new 1
>> Unknown command, perhaps 'new lower-room-number upper-room-number'?
>> > zedit new 99
>> Unknown command, perhaps 'new lower-room-number upper-room-number'?
>
>This is new in OasisOLC 2.0.1. It's support for CM3 bpl19's dynamic zone
>size. You just need to supply the bottom room # and top room # of the zone.
>
>However, since bpl19 hasn't been officially released yet, you should
>probably supply normal zone tops and bottoms until bpl19 is installed. For
>example, if you're making a new zone 1, use 'zedit new 1 100 199'.
I seem to have forgotten 'zone-number' in that message:
send_to_char("Unknown command, perhaps 'new zone-number lower-room-number
upper-room-number'?\r\n", ch);
BTW, it ignores lower-room-number and upper-room-number unless you use the
not-released bpl19.
--
George Greer
greerga@circlemud.org
--
+---------------------------------------------------------------+
| FAQ: http://qsilver.queensu.ca/~fletchra/Circle/list-faq.html |
| Archives: http://post.queensu.ca/listserv/wwwarch/circle.html |
+---------------------------------------------------------------+
This archive was generated by hypermail 2b30 : 12/06/01 PST